Failed to modify the DH485 Protocol configuration
NOTE:
Logix Designer versions 37 and later do not support controllers with serial ports. The
System Protocol
tab appears only in Logix Designer versions 36 and earlier for controllers with a serial port.There was a problem applying your DH485 protocol changes on the System Protocol tab of the Controller Properties dialog box. The error message you receive indicates one of the following conditions:
Enter Station Address in the range (0 - 31)
The value entered in the Station Address field is outside of the valid range. Enter a value from 0...31.
Enter Maximum Station Address in the range (0 - 31)
The value entered in the Maximum Station Address is outside of the valid range. Enter a value from 0...31.
Enter Token Hold Factor in the range (1 - 4)
The value entered in the Token Hold Factor is outside of the valid range. Enter a value from 1...4.
Provide Feedback